Lutron homeworks qs download full#
The experimental leapbridge supports full automated discovery of these systems, but authentication information must be manually entered.
Lutron homeworks qs download pro#
These can be changed in the bridge thing configuration.ĭiscovered keypad devices should have their model parameters automatically set to the correct value.Ĭaseta Smart Bridge hubs, Smart Bridge Pro 2 hubs, and RA2 Select main repeaters should be discovered automatically via mDNS.ĭevices attached to them need to be configured manually when using ipbridge. sysvar - System state variable (HomeWorks QS only) įull discovery is supported for RadioRA 2 and HomeWorks QS systems.īoth the main repeaters/processors themselves and the devices connected to them will be automatically discovered.ĭiscovered repeaters/processors will be accessed using the default integration credentials.blind - Lutron venetian blind or horizontal sheer blind.
shade - Lutron shade, motorized drape, or motor controller.cco - Contact closure output module or VCRX CCO.wci - QS Wallbox Closure Interface (WCI) (HomeWorks QS only).qsio - QS IO Interface (HomeWorks QS only).vcrx - Visor control receiver module (VCRX).virtualkeypad - Repeater/processor integration buttons or Caseta Smart Bridge scene buttons.grafikeyekeypad - GRAFIK Eye QS Keypad (RadioRA 2/HomeWorks QS only).palladiomkeypad - Palladiom Keypad (HomeWorks QS only).intlkeypad - International seeTouch Keypad (HomeWorks QS only).keypad - Lutron seeTouch or Hybrid seeTouch Keypad.occupancysensor - Occupancy/vacancy sensor.leapbridge - Experimental bridge that uses LEAP protocol (Caseta & RA2 Select only).ipbridge - The Lutron main repeater/processor/hub.This binding currently supports the following thing types: The binding has not been tested with Quantum, QS Standalone, myRoom Plus, or Athena systems. RA2 Select systems work with the binding, but full support for all devices still needs to be confirmed.Ĭaseta Smart Bridge (non-Pro model) support and support for Caseta occupancy sensors is available only through the experimental leapbridge thing. Homeworks QS support is still a work in progress, since not all features/devices are supported yet. Note: While the Lutron Integration Protocol used by ipbridge in this binding should largely be compatible with other current Lutron systems, it has only been fully tested with RadioRA 2, HomeWorks QS, and Caseta with Smart Bridge Pro. # Lutron RadioRA 2/HomeWorks QS/RA2 Select/Caseta Binding Grafik Eye 3x/4x systems with GRX-PRG or GRX-CI-PRG control interfacesĮach is described in a separate section below.